Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000633-01, June 2007)

34 Access Gateway Administrator’s Guide
53-1000633-01
ag
D
Displays the F_Ports that are mapped to a given N_Port. N_Port is optional
and if used, it displays the F_Ports that are mapped to the specified N_Port
only.
--mapset <N_Port > “<F_Port1;F_Port2;...>”
Maps F_Ports to a specific N_Port to the fabric. Any F_Port can be mapped to
only one N_Port. F_Ports are enabled only if the N_Port is online and NPIV is
enabled on the fabric port that is connected to Access Gateway.
--mapadd <N_Port> “<F_Port1;F_Port2;...>”
Adds F_Ports to existing N_Port. The traffic for the configured F_Ports to be
routed to the fabric through the specified N_Port when the F_Port comes
online. An F_Port can be mapped to only one N_Port. Specify the N_Port
number to which the F_Ports are to be mapped. This command modifies the
existing mapping for the N_Port. Specify the list of F_Port numbers to add to
the existing specified F_Port to N_Port mapping. The F_Port numbers must
be separated by semicolons.
--mapdel <N_Port> “<F_Port1;F_Port2;...>”
Removes the specified F_Ports from the N_Port mapping. Specify the N_Port
number to which the F_Ports are currently mapped. Specify the list of F_Port
numbers to remove from the specified F_Ports to N_Port mapping. The F_Port
numbers must be separated by semicolons.
--failovershow [N_Port]
Displays the failover policy for the N_Port. Use this command with the N_Port
parameter to see if the failover for this N_Port is enabled or not. If an N_Port
failure occurs when the failover policy is enabled, all F_Ports mapped to the
failed N_Port will failover to another N_Port connected to the same fabric, and
then those F_Ports are re-enabled.
--failoverdisable <N_Port>
Disables the failover policy for an N_Port.
--failoverenable <N_Port>
Enables the failover policy for an N_Port. When the failover policy is enabled
for an N_Port and failure occurs on that port, all F_Ports mapped to the failed
N_Port will failover to another N_Port connected to the same fabric, and then
those F_Ports are re-enabled.
--failbackshow [N_Port]
Displays the failover policy for the N_Port (s).
--failbackdisable <N_Port>
Disables the failback policy for an N_Port.
--failbackenable <N_Port>
Enables the failback policy for an N_Port.