Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000633-01, June 2007)

vi Access Gateway Administrator’s Guide
53-1000633-01
Chapter 4, “Managing Ports in Access Gateway mode” provides instructions on changing
N_Ports to F_Ports, mapping F_Ports to N_Ports, and changing failover and failback policies.
Chapter 4, “Managing Ports in Access Gateway mode” provides instructions on changing
N_Ports to F_Ports, mapping F_Ports to N_Ports, and changing failover and failback policies.
Appendix A, “Default Port Mapping” provides the default N_Port mappings for the different
switches while in Access Gateway mode.
Appendix B, “Compatibility” provides compatibility information between different devices while
running a switch in Access Gateway mode.
Appendix C, “Troubleshooting” provides symptoms and troubleshooting tips to resolve issues.
Appendix D, “Access Gateway Commands” provides the commands for Access Gateway.
The appendices provide the default mappings, compatibility guidelines, and troubleshooting
assistance.
What’s new in this document
The following changes have been made since this document was last released:
Information that was added:
Support for the following platform:
- Brocade 200E switch
Enhancements to the failback policy
Enhancements for compatibility
Information that was removed:
System messages were moved to the Fabric OS System Message Reference
All references to using Web Tools was moved to the Web Tool Administrator’s Guide
For further information, refer to the release notes.
Document conventions
This section describes text formatting conventions and important notices formats.
TEXT FORMATTING
The narrative-text formatting conventions that are used in this document are as follows:
bold text Identifies command names
Identifies the names of user-manipulated GUI elements
Identifies keywords and operands
Identifies text to enter at the GUI or CLI
italic text Provides emphasis
Identifies variables
Identifies paths and Internet addresses
Identifies document titles