Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 289
53-1000599-02
ipAddrSet
2
3. Additionally, the -eth0, -eth1, and -gate command line options are available with the --add or
--delete option on platforms with blade processors to set the BP Ethernet or Gateway
addresses. On an enterprise-class system with a blade processor the values for the blade in
slot n can be set from the command line using the -slot option. The -slot option is not accepted
in standalone application processors with a hidden blade, such as the AP7600.
Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
When used interactively to configure IPv4 addresses on an enterprise-class system:
-cp number Valid options include:
0 Sets the Ethernet IP address, Ethernet subnetmask, gateway IP address,
and host name of CP0.
1 Sets the Ethernet IP address, Ethernet subnetmask, gateway IP address,
and host name of CP1.
-sw number Valid options include:
0 Sets the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP
address, and Fibre Channel subnetmask of logical switch 0.
1 Sets the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP
address, and Fibre Channel Subnetmask of logical switch 1.
When used in command line mode, the following operands are supported:
-Ipv6 Specifies IP address type as static IPv6.
--add Specifies an address with prefix as needed.
--delete Specify an address to be deleted. If no address is specified, any existing IPv6
addresses and prefixes are deleted from the specified or implied entity.
-cp number | -sw number
On an enterprise-class system, specify CP or logical switch. Valid values for
number are 0 or 1.
On platforms with blade processors, the following additional command line options are supported
with the --add or --delete options:
-eth0 |-eth1 Specify local IPv4 address of blade processor. Prefix required.
-gate Specify IPv4 address of blade processor (BP) Gateway (no prefix).
-slot n On a chassis with a blade processor (BP), specify the slot number. On
standalone platforms with a hidden BP, such as the AP76500, this parameter
is not accepted.