Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 443
53-1000599-02
portCfgDefault
2
portCfgDefault
Restores the port configuration to factory default values.
Synopsis portcfgdefault [slot/][ge]port
Description Use this command to reset any special port configuration values to their factory defaults. This
command persistently disables ports capable of routing, which is the factory default value. You can
view the current port configuration using the portCfgShow command.
This command does not change the state of a port. To bring an E_Port go back online state, use
either switchDisable/switchEnable or portDisable/portEnable.
Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
slot For bladed systems only, specify the slot number of the port to be reset to
default, followed by a slash (/).
port Specify the number of the port to be reset to default, relative to its slot for
bladed systems. Use switchShow to list valid ports.
Examples To reset a port to factory defaults:
switch:admin> portcfgdefault 1/3
To reset a GbE port to factory defaults:
switch:admin> portcfgdefault 8/ge1
See Also portCfgEPort, portCfgGPort, portCfgLongDistance, portCfgLPort,
portCfgPersistentDisable, portCfgPersistentEnable, portCfgShow, portCfgSpeed,
portCfgTrunkPort