Brocade Fabric Watch Administrator's Guide Supporting Fabric OS v6.0.0 (53-1000601-01, October 2007)

ManualsBrandsHP ManualsStorageHP 4/16 SAN Switch Power Pack

36 Fabric Watch Administrator’s Guide

53-1000601-01

Configuring Fabric Watch thresholds

Fabric Watch displays the units of measurement (Unit), time base (Time base), low threshold (Low),

high threshold (High) and buffer size (BufSize) for each column (see Figure 14).

In Figure 14 a value of 80% is chosen as the custom high value for RXPerformance. The default

value is 100%.

1 : change behavior type 11 : change threshold alarm level

2 : change behavior interval 12 : change changed alarm

3 : change threshold boundary level 13 : change belowalarm

4 : change custom unit 14 : change abovealarm

5 : change custom timebase 15 : change inBetween alarm

6 : change custom low 16 : apply threshold alarm changes

7 : change custom high 17 : cancel threshold alarm changes

8 : change custom buffer 18 : return to previous page

9 : apply threshold boundary changes

10 : cancel threshold boundary changes

Select choice => : (1..18) [18]7

Enter high threshold =>: (0..100) [100] 80

Index ThresholdName BehaviorType BehaviorInt

216 eportRXPerf216 Triggered 1

217 eportRXPerf217 Triggered 1

218 eportRXPerf218 Triggered 1

219 eportRXPerf219 Triggered 1

220 eportRXPerf220 Triggered 1

221 eportRXPerf221 Triggered 1

222 eportRXPerf222 Triggered 1

223 eportRXPerf223 Triggered 1

Threshold boundary level is setat : Default

DefaultCustom

Unit Percentage(%) Percentage(%)

Time base minuteminute

Low 0 0

High 100 80

BufSize 0 0.

FIGURE 14 Customizing high threshold boundary for RXPerformance

Figure 15 shows how to change the threshold boundary level to custom so that the new custom

value of 80 is the new trigger point.

Figure 16 on page 37 shows how to apply the custom value; unless you apply the value, it does not

take effect.