Brocade Fabric Watch Administrator's Guide Supporting Fabric OS v6.0.0 (53-1000601-01, October 2007)

Fabric Watch Administrator’s Guide 51

53-1000601-01

Configuring Fabric Watch using Web Tools

Fan Alarm Action: (0..17) [0]

WWN Alarm State: (0..31) [0]

WWN Alarm Action: (0..17) [0]

Fru configuration left unchanged

FIGURE 22 fwFruCfg Configuration

You can specify triggers for any number of alarm states or alarm actions. The first prompt enables

you to select which FRU states trigger events.

To select a group of FRU states:

1. Add the numbers beside each state (for the states you want to include).

2. Enter the total at the prompt.

For example, to trigger events using the Absent, Off, and Faulty states, add the assigned values and

enter that value at the prompt. In this case, the values are 1, 8, and 16, respectively, and the total

is 25.

Configuring Fabric Watch using Web Tools

To configure Fabric Watch using Web Tools, see the Web Tools Administrator’s Guide.

Configuring Fabric Watch using SNMP

NOTE

The instructions given in this procedure apply to the AdventNet MIB browser. The procedure might

vary if you use other MIB browsers.

To configure Fabric Watch using SNMP

1. Open a MIB browser.

2. Load the appropriate MIB files. First, load the Brocade common MIB file (BRCD_v5_0.mib),

followed by the Brocade software MIB file (SW_v5_3.mib). If this is successful, the system

displays a screen similar to Figure 23.