Brocade Fabric Watch Administrator's Guide Supporting Fabric OS v6.0.0 (53-1000601-01, October 2007)

62 Fabric Watch Administrator’s Guide
53-1000601-01
Viewing Fabric Watch reports
4
Table 17 lists and describes each item in the port detail report.
Viewing Fabric Watch reports
You can view Fabric Watch reports in the following ways:
• “Viewing Fabric Watch reports using telnet,” next
• “Viewing Fabric Watch reports using Web Tools” on page 63
Viewing Fabric Watch reports using telnet
To view Fabric Watch reports using telnet, start a telnet session and enter the command (from
Table 18) corresponding to the report you want to view.
TABLE 17 Port detail report columns
Report item Description
LFA Link Loss: the number of link loss occurrences out of range for time period
LSY Sync Loss: the number of sync loss occurrences out of range for time period
LSI Signal Loss: the number of signal loss occurrences out of range for time period
PER Protocol Error: the number of protocol errors out of range for time period
INW Invalid word. The number of invalid words out of range for time period
CRC Invalid CRC: the number of CRC errors out of range for time period
PSC Port hardware state changed too often due to fabric reconfiguration
BLP Buffer limited port: the switch status changes when a port is in a buffer limited mode based
on the switch status policy.
STM SFP temperature is out of specifications
SRX SFP receive power is out of specifications
STX SFP transmit power is out of specifications
SCU SFP current is out of specifications
SVO SFP voltage is out of specifications
TABLE 18 Telnet commands for viewing Fabric Watch reports
Use the command To view
fwSamShow Port failure rate report
switchStatusShow Switch health report
switchStatusPolicyShow Switch status policy report
fwPortDetailShow
fwPortDetailShow --s h
fwPortDetailShow --s m
fwPortDetailShow --s f
fwPortDetailShow --s o
Port detail report
To view only health ports
To view only marginal ports
To view only faulty ports
To view only offline ports