HP StorageWorks Fabric Manager 5.x Administrator Guide (AA-RUQSF-TE, September 2005)

30 Installation
b. Click Next.
The Introduction window opens.
7. Read the introduction and then click Next.
The Select Destination Folder window opens.
8. Use the default location, or click Choose to select a new folder.
You can also enter a new destination folder. The path should not contain spaces.
9. Click Next.
The Select FTP Server window opens.
10.Select your FTP server options.
The FTP server is used primarily for firmware download.
11.Click Install.
You are prompted to wait while Fabric Manager is installed on your machine. The Please Specify
Starting Port Number window opens.
12.Enter the starting port number. The default is 24600.
If the default starting port number is not a free port number, the server cannot start up correctly. If you
enter a new port number, you must ensure that it and the next five port numbers represent free ports.
Make note of the port number that you enter: you must use the same port number during the client
installation.
NOTE: If you are upgrading or migrating from a previous version of Fabric Manager, you might receive
a message indicating that the ports are unavailable. This can occur when the ports have yet to be
released by the previous uninstall. Wait a few minutes and try again.
13.Click Next.
You are prompted to wait while Fabric Manager configures your machine.
You are then prompted to select an authentication method:
• Windows domain or workgroup
• Switch based authentication
• RADIUS server authentication
14.Select your authentication method and then click Next.
• For Windows authentication: Enter the windows domain or workgroup name and then click Next.
NOTE: If your machine is running Windows XP and it belongs to a local workgroup, but you want to
authenticate the users locally (instead of using a Windows domain controller), you must perform the
following Windows XP registry configuration:
1. Set HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Lsa\ForceGuest to 0.
2. Disable the guest account.
3. Create a local user and use it to login from Fabric Manager.
The SAN Size Selection window opens.
• For RADIUS server authentication: Configure at least two RADIUS servers so that if one fails, the
other can assume service. You can configure up to three RADIUS servers.
a. Enter values for the following:
• RADIUS server IP address or DNS name.
• RADIUS authentication port number.
• Authentication type. The authentication type should match the setting on your RADIUS server.
• Shared secret and confirm shared secret. The shared secret is a password for the RADIUS client
and server. It is used in an encryption process to obscure details (like user passwords) in RADIUS
messages.