HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (A7511-90902, May 2007)

14 SAN Switch rack mount kit installation instructions

c. To attach the inner rails to the SAN Switch 2/32 use the screw holes

marked 32 .

d. To attach the inner rails to the MP Router, use the screw holes marked

e. To attach the inner rails to the SAN Switch 4/32, 4/32B SAN

Switch, 4/64 SAN Switch or the 400 MP Router use the screw holes

marked 16.

Caution: Remember to use the screw holes labelled 8 when attaching the

inner rails to the SAN Switch 2/16V or SAN Switch 2/16N.

7. Assemble the two inner rails (one on each side) to the device using the

appropriate number of screws (see Table 2).

For example, Figure 6 shows an inner rail attached to the MP Router with

three screws using the rail screw holes marked R. Please note that

attaching both rails require six screws.

Also, Figure 7 shows an inner rail attached to the 4/64 SAN Switch with

five screws using the rail screw holes marked 16 . Please note that

attaching both rails require ten screws.