HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (A7511-90902, May 2007)

16 SAN Switch rack mount kit installation instructions
Note: For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head
screw with thread lock and torque between 6 to 8 inch-pounds.
8. If installing one of the following switches, you must install the plenum that
ships in the accessory kit with the rack mount hardware:
■ SAN Switch 2/8V
■ SAN Switch 2/16
■ SAN Switch 2/16V
■ 4/8 SAN Switch
■ 4/16 SAN Switch
■ 4/32B SAN Switch
See Installing the Plenum (if required), page 17 for complete installation
instructions.
If not installing one of the devices listed in step 8, go to Securing the
Device to the Outer Rails, page 18 to complete the rack mount
procedure.