HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (A7511-90902, May 2007)

18 SAN Switch rack mount kit installation instructions
Securing the Device to the Outer Rails
To secure the device to the outer rails:
1. Insert the switch with the attached inner rails into the outer rails.
Note: This step applies to installing a switch in HP 9000 Series, HP 10000 Series or HP
System/e racks.
2. Insert the device into the rack and install (2) #10-32 x 1/2-inch Phillips
pan-head screws with captive star lock washers with one on each side.
See Figure 9 and Figure 10.
Figure 9: Securing the Device (in HP 9000 Series or HP 10000 Series Racks)