HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (A7511-90902, May 2007)

6 SAN Switch rack mount kit installation instructions
Using the SAN Switch Rack Mount Kit to Install an
HP StorageWorks Device
Read this section to install a SAN Switch or MP Router in an HP 9000 Series,
HP 10000 Series, HP 10000 G2 Series
or HP System/e rack.
Note: The SAN Switch Rack Mount Kit installation requires one technician.
Required Tools and Hardware
Obtain the following items:
■ #2 Phillips screwdriver
■ 7/16-inch wrench or socket
■ HP StorageWorks device, see Supported Devices on page 3
■ Plenum (if required), see Before You Begin - Important Information about
the Plenum, page 4
■ Power cables
■ SAN Switch Rack Mount Kit hardware (smaller items like screws ship in
plastic bags in the kit), see Table 1
Table 1: Hardware included in the SAN Switch Rack Mount Kit
Item Description
Two (2) rear mounting brackets
A right inner rail and a right outer rail
A left inner rail and a left outer rail