HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (A7511-90902, May 2007)

8 SAN Switch rack mount kit installation instructions
To install the HP StorageWorks device in a rack:
Note: Figures and procedures throughout this document use “HP 10000 Series
Rack” to reference both 10000 Series rack models (HP 10000 Series Rack and HP
10000 G2 Series Rack).
1. Check the contents of the SAN Switch Rack Mount Kit shipping carton to
verify that all the required parts and hardware are available. See
Table 1, Hardware included in the SAN Switch Rack Mount Kit.
2. Choose a mounting location in the rack.
3. Attach the rear mounting brackets to the rear rack uprights by completing
one of the following steps:
— For HP 10000 Series racks, assemble each of the two brackets with
two #10-32 x 1/2-inch Phillips pan-head screws with captive star
lock washers and two #10 adapter washers as shown in Figure 1.
Figure 1: Installing the Rear Mounting Brackets (HP 10000 Series Racks)