zl Modules Installation Guide 2011-11

HP Switch zl Modules

Figure 1. Software upgrade process

Steps to Update the E8212 zl Module Software

1. Copy new software to primary or secondary flash memory on acitive

management module:

USB – E8200zl#copy usb flash K_13_60.swi pri

TFTP – E8200zl#copy tftp flash 192.168.248.10

k_13_60.swi pri

After downloading a new software version to either the primary or

secondary flash of the active management module, the software version

is immediately copied to the corresponding flash (primary or secondary)

of the standby module unless the standby module failed selftest or

redundancy was disabled with the no redundancy management-module

command.

2. Make sure boot setting is configured to boot to correct flash to which the

software was copied.

E8200zl#boot set-default flash primary

E8200zl#write memory

This change will also be synchronized to standby management module.

3. Boot standby module

E8200zl#boot standby