zl Modules Installation Guide 2011-11

Then tighten the retaining screws
on the module until they are secure,
but do not overtighten them.
Use the extractor handles to
seat the module completely.
19
Installing the Modules
Figure 7. Module fully installed
Installing or Removing a mini-GBIC or SFP transceiver
You can install or remove a mini-GBIC or SFP transceiver from the mini-GBIC
zl Module without having to power off the switch. Use only HP mini-GBICs or
SFP transceivers.
WARNING The HP mini-GBICs and SFPs are Class 1 laser devices. Avoid direct
eye exposure to the beam coming from the transmit port.
Caution Use only supported genuine HP mini-GBICs or SFP transceivers with your
switch. Non-HP mini-GBICs or SFP transceivers are not supported, and their
use may result in product malfunction. Should you require additional HP mini-
GBICs or SFP transceivers, contact your HP networking Sales and Service
Office or authorized dealer.
Installing the mini-GBICs or SFP transceivers:
Hold the transceiver by its sides and gently insert it into any of the slots in the
module until it clicks into place.