zl Modules Installation Guide 2011-11

20
Installing the Modules
Figure 8. Example: Mini-GBIC or SFP transceiver being installed
Removing the mini-GBICs or SFP transceivers:
Disconnect the network cable from the transceiver before removing it from
the module. Depending on when you purchased your transceiver, it may have
either of three different release mechanisms: a plastic tab on the bottom, a
wire bail, or a plastic collar.
To remove the transceivers that have the plastic tab or plastic collar, push in
the plastic tab or collar toward the switch until you see the transceiver release
from the switch (you can see it move outward slightly), and then pull it from
the slot.
To remove the transceivers that have the wire bail, lower the bail until it is
approximately horizontal, then using the bail, pull the transceiver from the
slot.