MSM7xx Controllers Release Notes v6.2.1.0

• Configuration backup using IMC fails for all MSM devices.

• The firmware updates feature does not work properly.

• The following misleading error message has been removed:

<CONTROLLER NAME> <IP ADDRESS> debug webredirect: SSL Error occurred

while reading: error:140760FCSL routines: SL23_GET_CLIENT_HELLO:unknown

protocol (336027900)

• When a controller location is set to Morocco, APs can fail to synchronize when a radio is set to

802.11n and the 5 GHz band is being used for local mesh.

• When user is authenticating with a remote trusted domain, if LDAP information cannot be retrieved

and a user group is not found, the user is still allowed to log in.

• An MSM7xx Controller can reboot during heavy simultaneous authentication traffic load.

• Whenever a wireless client roams from one AP to another using MAC Authentication, the client

session is terminated and does not restart until the client issues a new DHCP request.

• The MSM Controller continues to respond to DHCP requests on the LAN port after that feature

has been disabled.

• HTML authentication does not work if the user name contains spaces.

• The PayPal service does not accept guest credit card direct purchases.

• Using SOAP functions directed to a non-configured IP address causes SOAP to fail and add the

following error message to the controller log:

websoap: SOAP FAULT: SOAP-ENV:Client "Internal error" websoap: Unable

to communicate with IPRulesMgr, Timeout occurred.

• Using an external RADIUS server and an access controlled VSC can cause the MSM7xx Controller

to reboot.

• A wireless client moving to a wired connection is not asked to re-authenticate when using 802.1x

and an external Active Directory server, but should be.

• The SOAP command GetAuthenticatedUsers was deprecated. The new function

GetAuthenticatedUsersSessions can be used instead.

• In high capacity environments such as teaming with a large number of APs and with LLDP in use,

APs can randomly lose synchronization during high traffic periods.

• On a rare occasion, when a wireless client roams from one AP to another, the client traffic stops

until it moves to a new AP and the following error message appears on the controller log:

iprulesmgr: The RADIUS Accounting Request packet (id='17') received

contains a Called-Station-Id attribute (length='33') that isn't

recognized as being a MAC address, this may affect Location-Aware

related functionnalities such as restriction or incorrect VSC

assignment.

• When using HTML authentication, the Continue browsing link incorrectly redirects the wireless

client back to the home page.

• Added the following SOAP function to allow mapping of a network profile to a local mesh interface:

AddVLANOnLocalMesh()

• Added the following SOAP commands to autonomous mode APs:

To configure the Station ID delimiter used in the Called-Station-Id content in the RADIUS

request:

◦

UpdateVirtualSC8021XStationIdDelimiterAndCase

8 Fixes