MSM3xx/MSM4xx and HP 425 Access Points Release Notes v6.2.0.1

Old page
New page
Using the new firmware validation options
CAUTION: Always make a backup of your existing configuration before installing new firmware.
Manual install
To manually update the AP software, do the following:
1. Select Browse, and then locate a firmware file and select it.
2. Select Validate if you want to test the integrity of the selected firmware file without installing it. A
message will appear at the top of the page indicating whether the firmware signature is valid or
invalid.
3. Select Install. This will automatically test the integrity of the firmware by validating its signature.
If the signature is valid, the firmware will be installed and the AP will restart. If the signature is
invalid, the firmware will not be installed.
NOTE: Select Force install to install a firmware file without validating its integrity. Installing firmware
without validating its integrity may result in the AP becoming inoperative. This option should generally
only be used under the guidance of HP support personnel.
6 Changes to the management tool interface