MSM7xx Controllers Configuration Guide v6.4.0

Recommended settings for dual radio APs:
• With IDS disabled, configure both radios for Operating band only.
• With IDS enabled, configure the 2.4 GHz radio for Operating band only (with a small scan
ratio), and configure the 5 GHz radio for All bands (with a larger scan ratio). The 2.4 GHz
band is probably much busier than the 5 GHz band, so IDS scanning using the 5 GHz radio
has a reduced performance impact.
Channels to scan
• All channels: Scan all channels supported by the current operating mode.
• Regulatory channels only: Scan only channels supported by the current regulatory domain
(country).
• Non-excluded channels only: When enabled, the AP will not scan any channels in the Automatic
channel exclusion list.
Neighbor detection time
Estimated time in seconds to detect a neighbor.
Viewing wireless information
Viewing all wireless clients
To view information on all wireless client stations, select Controlled APs >> Overview > Wireless
clients.
This page lists all wireless clients associated with all VSCs.
Settings
AP name
Name of the AP the with which the client station is associated.
Radio
Radio on the AP that the client station is using.
MAC Address
MAC address of the client station. Select the MAC address to view more detailed information
on the client.
IP address
IP address assigned to the client station.
Username
Name with which the user logged in.
SSID
SSID assigned to the client station.
Security
Indicates if the client station has been authorized.
102 Wireless configuration