MSM7xx Controllers Configuration Guide v6.4.0

To delete a group, do the following:
1. Select Controlled APs >> Group management.
2. Select the name of the group you want to delete.
3. Select Delete.
Binding a VSC to a group
This procedure applies to wireless users only. On the HP 517 or MSM317, VSC binding for wired
users (connected to the switch ports) are done individually for each port.
To bind a VSC to a group, do the following:
1. Select the target group under Controlled APs.
2. In the right pane, select VSC bindings, then select Add New Binding.
3. Select the VSC profile to which the group will be bound.
4. If you want to assign an egress mapping to the binding, select Egress network and select the
required Network profile. The Egress network can be used to assign all traffic on the group
to a specific VLAN. Other uses are also possible depending on the type of VSC to which the
group is being bound. For more information, see “Traffic flow for wireless users” (page 221).
5. Select Save.
Working with APs
Manually adding a new AP
You can manually add APs to the controller before connecting the APs to the network. This is useful,
for example, when you want to pre-designate the group into which an AP will be placed.
1. Select Controlled APs >> Overview > Configured APs.
2. Select Add.
Configuring APs 165