MSM7xx Controllers Configuration Guide v6.4.0

To delete an AP:
1. Select Controlled APs >> Overview > Configured APs.
2. Select the AP name in the Overview table. This opens the AP management page. Select Delete.
The AP is then deleted.
Moving an AP to a different group
NOTE: Moving an AP to a different group causes it to be restarted.
Using drag-and-drop
The easiest way to move an AP to a different group is to drag-and-drop it from the old group to
the new group. Both groups must be visible in the Network Tree for this to work.
The move to the different group does not actually occur until the AP is synchronized as described
in the next section, “Synchronizing APs” (page 169).
Using menus
1. In the Network Tree select the AP and then on the main menu, select Device Management >
AP management.
2. Under Access point settings, select the desired Group and select Save.
This puts the AP into the unsynchronized state (it will be displayed in orange). The move does
not occur until the AP is synchronized as described in the next section.
Moving multiple APs between groups
To move one or more APs between groups, do the following:
168 Working with controlled APs