MSM7xx Controllers Configuration Guide v6.4.0

Define provisioning settings as described in “Displaying the provisioning pages” (page 172).
NOTE:
• Until this option is enabled, provisioned settings defined on the controller are not sent to any
controlled APs.
• After an AP has been updated with provisioned settings, these settings do not become active
until the AP is restarted, or a Remove and rediscover action is executed on the Controlled APs
>> Configured APs page.
Directly provisioning an AP using its management tool
In its factory default state, the AP provides a provisioning menu with the same options that are
available on the controller. Use this method when there is no local controller on which to perform
the provisioning. See “Displaying the provisioning pages” (page 172).
NOTE: Once an AP has established the secure management tunnel with a controller, the
provisioning menu on the AP is no longer accessible.
In both cases, the configuration settings that you have access to are the same. They are described
in the following sections.
Displaying the provisioning pages
To display the provisioning pages, do the following:
On a controller
1. Select one of the following in the Network Tree:
• Controlled APs
• A group
• An AP
2. In the right pane, select Provisioning > Connectivity.
3. Configure provisioning settings as described in the sections that follow.
On an AP in its factory-default state
1. Log in to its management tool.
2. Select Provision at the bottom of the home page.
172 Working with controlled APs