MSM7xx Controllers Configuration Guide v6.4.0

The following page will appear on the HP 517 and MSM317.
Enable provisioning here:
Settings
Interface
Select the interface you want to configure and then define its settings using the other options
on this page. Set VLAN ID if applicable.
Assign IP address via
• DHCP client: Address is assigned using a DHCP server. Enable this option to have the
interface act as a DHCP client. The AP sends DHCP requests on the specified VLAN. If no
VLAN is specified, the request is sent untagged.
• Static: Select this option to manually assign an IP address to the interface.
Static IP settings
When you select Static for Assign IP address via, configure settings in this box.
• IP address: Specify the IP address you want to assign to the interface.
• Address mask: Specify the appropriate subnet mask for the IP address you specified.
• Default gateway: Specify the IP address of the default gateway.
Local mesh settings
For information on provisioning these settings, see “Local mesh” (page 384). (Not supported on
the HP 517 or MSM317.)
Country
Select the country in which the AP is operating.
CAUTION:
• Selecting the wrong country may result in illegal operation and may cause harmful
interference to other systems. Please consult with a professional installer who is trained in
RF installation and knowledgeable about local regulations to ensure that the controller is
operating in accordance with channel, power, indoor/outdoor restrictions and license
requirements for the intended country.
• The Country option is not available on APs delivered with a fixed country setting.
174 Working with controlled APs