MSM7xx Controllers Configuration Guide v6.4.0

On all other controllers
4. Under Map to, select the port to which the VLAN will be bound. On the MSM720, you can
select multiple ports or a trunk (Only static trunks appear in the list, dynamic trunks are
automatically mapped to the default VLAN).
5. On the MSM720, select one of the following for Mode and then select Apply:
• None: No VLAN is assigned to the port.
• Tagged: Traffic on the port is sent/received using the VLAN tag defined for the selected
network profile(s).
• Untagged: Traffic on the port is sent/received untagged. However, if a VLAN is defined
for the selected network profile(s), it is used internally within the controller.
6. Select Save.
Assigning VLANs to controlled APs
VLANs can also be assigned to ports on controlled APs at one of the three following levels:
• Base group level by selecting Controlled APs >> Configuration > VLANs.
• Group level by selecting Controlled APs > [group] >> Configuration > VLANs.
• AP level by selecting Controlled APs > [group] > [AP] >> Configuration > VLANs.
In all cases, the VLANs page presents the same options that are available at the controller level (
See “Defining a VLAN on a controller port” (page 219) for details.).
For example, if you select Controlled APs >> Configuration > VLANs, select two ports, select Add
New Mapping, and then select Apply.
220 Working with VLANs