MSM7xx Controllers Configuration Guide v6.4.0

When using an access-controlled VSC
In this example, all wireless stations are connected to an access-controlled VSC. Bonjour gateway
is enabled on the controller and configured to relay Bonjour traffic between Network 1 and Network
2. Traffic management is also enabled.
1. User 1 sends a multicast query for a printer.
2. AP 1 forwards the query through the control channel to the controller. It does not multicast the
query onto Network 1.
3. The controller receives the query. The Bonjour gateway feature on the controller relays the
query to the VSC egress, which in this case is set to Network 2.
4. Printer 3 receives the query and sends a multicast response.
5. The controller sends the response into the control channel to AP 1, where it is forwarded as
a unicast to User 1.
(Note: If the VSC egress is configured for <Default> then the query would be forwarded onto all
interfaces on which Bonjour gateway is enabled. However, the gateway cannot be enabled on
the same Network or VLAN on which the control channel is active.)
Configuring traffic management
Do the following to enable and configure traffic management:
Bonjour traffic management 237