MSM7xx Controllers Configuration Guide v6.4.0

4. Select the Team manager checkbox, and configure the following settings under it:
• Set Team name to a name that identifies the team. This example uses Team 1. The team
name provides a convenient way to identify a team.
• Set Team management IP address to the virtual IP address that will be used to provide
access to the management tool on the team manager. This example uses the address
192.168.2.200. This address must be on a different subnet than the IP address assigned
under Control channel. However, it can be on the same subnet as the selected interface.
• Set Mask to 255.255.255.0.
• Set Interface to Internet network. This makes the Team management IP address available
on ports 5 and 6.
5. Select Save.
6. Controller 2 will now attempt to discover the manager. Monitor the Summary box until you
see an Unauthorized controller in the list.
Indicates team manager is synchronized.
Indicates team manager and a new controller were detected.
Indicates team manager is configured.
Indicates new controller has been discovered.
7. Under Network Tree, select Controllers to view more detailed information about the discovery
process. The two new controllers should be listed in red. Select Authorize in the Action column
for the controller.
256 Controller teaming