MSM7xx Controllers Configuration Guide v6.4.0

Admin Down
Indicates the number of APs that are Offline and have been manually set to Admin Down
(Administratively Down) by an administrator. This state is used to flag an AP that is known to
be offline. For example, for maintenance or relocation.
Access Points Utilization
Indicates the number of APs that are able to exchange management information with the
controller. Displays the number of APs currently operating in each bandwidth utilization range:
<50%, 50% - 80%, >80%.
Only online access points with radios that are enabled and operating in access point or local
mesh mode are shown on this chart.
The percent utilization is calculated by comparing the total throughput (transmitted/received)
of all radios on an AP for the last minute against the maximum throughput that the radios could
theoretically achieve.
Alarms
Displays the total number of active alarms for each severity.
Total
Total number of active alarms for all severities.
Critical (Red)
Alarms with this severity indicate a failure and signal the need for immediate attention.
Major (Orange)
Alarms with this severity indicate an impending failure.
Minor (Yellow)
Alarms with this severity indicate a warning condition that can escalate into a more serious
problem.
Wireless clients tab
Provides information about the wireless clients connected to all controlled APs. For example:
26 Dashboard