MSM7xx Controllers Configuration Guide v6.4.0
Viewing discovered controllers
To display information about controllers discovered by the manager, select Controllers >> Overview
> Discovered controllers.
The Discovered controllers page provides the following:
• Select the action to apply to all listed controllers: Lets you apply the selected action to all
controllers in the list. Select an action and then Apply.
• Status lights
A status light is displayed for each controller as follows:
◦ Green: The controller has joined the team and its configuration is synchronized with the
settings defined on the team manager. It is fully operational.
◦ Red: The controller is not functioning normally. Select Overview > Discovered controllers
and refer to the Diagnostic column for details.
◦ Grey flashing: An action is pending. Select Overview > Discovered controllers and refer
to the Action column for details.
◦ Grey solid: The controller is configured as a member of the team, but is currently not
active.
• Controller name: Name assigned to the controller. By default, this is the controller serial
number.
• Serial number: Unique serial number assigned to the controller at the factory. Cannot be
changed.
• Access points: Indicates number of APs connected to the controller.
• Diagnostic: Indicates the status of the controller as shown in the following table.
DescriptionDiagnostic
The controller sent a discovery request to the team manager and the team manager
has replied.
Detected
A secure management connection is being established between the team manager
and the controller.
Establishing tunnel
New software failed to upload to the controller. The manager will retry soon.Firmware failure
New software has been successfully uploaded to the controller. The controller
will restart to activate the new software.
Installing firmware
The controller has not yet been authorized to join the team. Authorization must
be performed manually by an administrator by selecting Authorize in the Action
column.
Not authorized
The controller has stopped sending management information to the team manager.
Rediscovery may re-establish the connection. If not, a network failure may have
occurred or the controller may be inoperative.
Not responding
Controller discovery 265