MSM7xx Controllers Configuration Guide v6.4.0

5. Select Save.
You can now configure mobility options, such as home networks, as explained in “Mobility traffic
manager” (page 285).
Single controller team operating with non-teamed controllers
In this type of setup, the team is configured as the primary mobility controller and the non-teamed
controllers set the IP address of primary controller parameter to the team IP address. (In this scenario,
the team IP address is defined on the LAN port of the team manager.)
1
Primary mobility
controller
L3 switch
2
Controller team Independent controllers
3
4
Controlled APs
1.1
Team IP =
192.168.1.99
1.2 3.1 4.1
Configure the team
1. Start the management tool on the team manager by pointing your browser to the team IP
address.
2. Select Team: [name ] >> Management > Device discovery.
3. Select Mobility controller discovery.
4. Select This is the primary mobility controller.
Mobility support 275