MSM7xx Controllers Configuration Guide v6.4.0

3. Disable Network address translation (NAT).
4. Select Save.
Enable DHCP relay globally
In order for wireless client stations to obtain an IP address, the controller must act as a DHCP relay
agent to forward requests to the external DHCP server at 10.0.0.1.
1. Select Team >> Network > Address allocation. The Address allocation configuration page
opens.
2. Select DHCP relay agent and then select the Configure button next to it.
3. The DHCP relay agent configuration page opens.
• Under Listen for requests on, disable LAN port and enable Client data tunnel.
• Set Primary server address to a dummy IP address.
• Enable the Extend VSC egress subnet to the VSC ingress subnet option. (Although this
option is only useful when a VLAN is used as the egress on a VSC, HP recommends that
it always be enabled.)
• Select Save.
282 Controller teaming