MSM7xx Controllers Configuration Guide v6.4.0

Create a new VSC for guest access
The default VSC cannot be used for guest access when teaming is enabled, so a new VSC must
be created.
1. Select VSC >> Add new VSC profile.
2. The VSC profile page opens. Configure the following settings:
• Define a name for the VSC and enable Authentication and Access control.
• Define the SSID name for the wireless network.
• Enable the HTML-based user logins option. (This allows users to log in to the protected
network using their web browsers.)
• Set the VSC egress mapping to <Default> for all types of traffic since VLANs are not being
used. This sends all authenticated traffic out via the Internet port.
• Enable the DHCP relay agent checkbox and select Forward to egress interface. (Do not
specify a Circuit ID or Remote ID. These options are not supported when teaming is
enabled.)
3. Select Save.
Guest access and teaming 283