MSM7xx Controllers Configuration Guide v6.4.0

Local networks
Select the local networks that are connected to the Ethernet port(s) on the AP.
• Available networks: This box lists all network profiles defined on the controller. Select a network
profile and then select the right arrow to assign it as a local network on the AP.
• Local networks: This box lists all the networks that are local to the AP. These networks are
used to determine if a user is roaming or at home when they connect to the AP.
◦ If a users home network matches a local network on the AP, the user is considered to be
at home, and their traffic is bridged onto the wired network via the Ethernet port on the
AP.
◦ If a users home network does not match a local network on the AP, the user is considered
to be roaming, and their traffic is tunneled to appropriate home network via the controllers
that make up the mobility domain.
NOTE: The Subnets feature has been deprecated. See “Subnet-based mobility” (page 330) for
more information.
Configuring the mobility settings for a VSC
Once all home and local networks have been assigned, you can configure VSC definitions to
support MTM.
1. Select the Controller > VSCs > [ VSC-name ].
2. Disable the Access control option under Global.
3. Select Wireless mobility, and under it, select Mobility traffic manager.
294 Mobility traffic manager