MSM7xx Controllers Configuration Guide v6.4.0

WPA is enabled on the VSC to control user authentication. When the user logs in, the VLAN is
retrieved from the account profile and is used by MTM to route the users traffic to the appropriate
network via the Internet port.
Home network =
Network 4
Home network =
Network 3
LAN port
192.168.1.1
Internet port
192.168.40.1
W
L
A
N
W
L
A
N
2
1
User B
User A
Network 2
192.168.20.0
Network 1
192.168.10.0
Network 4
192.168.40.0
Network 3
192.168.30.0
User B User A
Configuration overview
The following sections provide a summary of the configuration settings needed to enable MTM
support only. It is assumed that installation and configuration of all controllers and APs so that they
are fully operational on the network was performed as explained in the other chapters in this guide.
VSC configuration
Enable MTM support on the VSC.
Scenario 3: Centralized traffic on a controller with per-user traffic routing 305