MSM7xx Controllers Configuration Guide v6.4.0

By assigning different VLANs to different controller ports, traffic can be split between controllers.
To reduce the amount of traffic that needs to be tunneled between controllers, APs are assigned
to controllers based on their expected use:
• AP 1 is physically located in an area where most of the users as assigned to network 1,
therefore it is managed by controller 1.
• AP 2 is physically located in an area where most of the users as assigned to network 2,
therefore it is managed by controller 2.
A RADIUS account is defined for each user with attributes set to identify their home network using
one of the network profile names:
Network
administrators
Network 3 usersNetwork 2 usersNetwork 1 usersRADIUS attribute
802802802802Tunnel-Medium-Type
NOCNet3Net2Net1Tunnel-Private-Group-ID
VLANVLANVLANVLANTunnel-Type
Configuration overview
The following sections provide a summary of the configuration settings needed to enable MTM
support only. It is assumed that installation and configuration of all controllers and APs so that they
are fully operational on the network was performed as explained in the other chapters in this guide.
Controller 1 configuration
Mobility domain
1. Select Controller >> Management > Device discovery.
• Select Mobility controller discovery.
• Select This is the primary mobility controller.
(For a complete screenshot of this page, see “Defining the mobility domain” (page 291).)
2. Select Save.
318 Mobility traffic manager