MSM7xx Controllers Configuration Guide v6.4.0

9. Select Add New Interface to open the Add/Edit interface page.
10. Under Interface, select the network profile that you defined earlier.
11. Under Assign IP address via, select the addressing method to use.
• DHCP client: Dynamic host configuration protocol. The DHCP server will automatically
assign an address to the network profile, which functions as a DHCP client.
• Static: Specify an IP address, Mask, and Gateway.
12. Enable/disable NAT support if required.
13. Select Save. The new interface is added to the IPv4 interfaces table.
Configuring the Access network/LAN port interface
The following configuration options are available if you select the Access network interface (on an
MSM720) or LAN port interface (on all other controllers) in the table.
38 Network configuration