MSM7xx Controllers Configuration Guide v6.4.0

Jack
Supported on the MSM765 zl and MSM775 zl only.
Indicates the jack (physical interface) to which a port is assigned.
Name
Identifies the port.
Duplex
Not supported on the MSM765 zl and MSM775 zl.
Indicates if the port is Full or Half duplex.
Speed
Not supported on the MSM765 zl and MSM775 zl.
Indicates the speed at which the port is operating.
Trunk type
Only supported on the MSM720.
Indicates the type of trunk to which the port is assigned:
• None: The port is not assigned to a trunk.
• Trunk: The port is assigned to a static trunk.
• LACP: The port is assigned to a dynamic trunk that uses LACP (active mode).
Trunk group
Only supported on the MSM720.
Indicates the trunk group to which a port is assigned.
• Trunk n: The port is assigned to a static trunk, with n indicating the trunk number (1 to 6).
• Dyn n: The port is assigned to a dynamic trunk (LACP), with n indicating the trunk number
(1 to 6). A separate LACP trunk is automatically created for each LACP-enabled switch to
which the MSM720 is connected. For example, if you connect ports 1 and 2 to switch 1,
and ports 3 and 4 to switch 2, then the controller automatically creates the groups Dyn 1
and Dyn 2.
MAC address
Indicates the MAC address of the port.
Configuring MSM720 ports
All MSM720 ports have the same configuration settings, for example, Port 1:
Configuring port settings 43