MSM7xx Controllers Configuration Guide v6.4.0

Framed-MTU
(32-bit unsigned integer)
Hard-coded to 1496 (802.1X). Hard-coded value of 1496. The value is always four bytes
lower than the wireless MTU maximum which is 1500 bytes in order to support
IEEE802dot1x authentication.
NAS-Identifier
(string)
The NAS ID set on the Controller >> Authentication > RADIUS profiles > Add New Profile
page for the RADIUS profile being used.
NAS-Ip-Address
(32-bit unsigned integer)
The IP address of the port the controller is using to communicate with the RADIUS server.
NAS-Port
(32-bit unsigned integer)
Always 0.
NAS-Port-Type
(32-bit unsigned integer)
Always set to 19, which represents WIRELESS_802_11.
Message-Authenticator
(string)
As defined in RFC 2869. Always present even when not doing an EAP authentication.
length = 16 bytes.
Service-Type
(32-bit unsigned integer)
RADIUS service type.
State
(string)
As defined in RFC 2865.
User-Name
(string)
The RADIUS username assigned to the controller on the Public access > Attributes page.
User-Password
(string)
The password assigned to the controller on the Public access > Attributes page. Encoded
as defined in RFC 2865. Only present when the authentication method for the RADIUS
profile is set to PAP.
Vendor-specific (Microsoft)
HP ProCurve supports the following Microsoft vendor-specific attributes.
MSCHAP-Challenge
(string)
As defined in RFC 2433. Only present when the authentication method for the RADIUS
profile is set to MSCHAPv1 or MSCHAPv2. Length = 8 bytes.
MSCHAP-Response
As defined in RFC 2433. Only present when the authentication method for the RADIUS
profile is set to MSCHAPv1. Length = 49 bytes.
440 Working with RADIUS attributes