MSM7xx Controllers Configuration Guide v6.4.0

Can be omitted if a remote login page is being used. See Remote login page.
Transport page
transport-page=URL_of_page [placeholder ]
Session page
session-page=URL_of_page [placeholder ]
Fail page
fail-page=URL_of_page [placeholder ]
Logo
logo=URL_of_gif_file [placeholder ]
Placeholder
The following placeholder is only available when using a RADIUS server. If these values
are specified under Controller >> Public access > Attributes > Configured attributes, the
placeholder cannot be used.
DescriptionPlaceholder
Returns the IP address of the controller Internet port.%a
Hosting pages on an external Web server
Use the following values to reference pages that reside on an external Web server.
NOTE: The maximum length of any page URL is 512 characters. If this is exceeded (when
using placeholders for example), the URL is truncated. Therefore, HP recommends that you
specify the most-important placeholders first.
NOTE: The controller maintains a separate copy of the URLs for external pages for each user.
This means it is possible to provide different pages for each user. See “Displaying custom
welcome and goodbye pages” (page 406).
Welcome page
welcome-url=URL_of_page [placeholder ]
The user is authenticated, so the welcome page can be located on any URL reachable by the
user.
Login error page
login-err-url=URL_of_page [placeholder ]
Access to the Web server hosting this page must be granted to all unauthenticated users. Do
this with an appropriate access list definition. (Users can see this page before they are logged
in.)
if the radius server denies user authentication, this is used instead of an error being presented
on the login page.
Goodbye page
goodbye-url=URL_of_page [placeholder ]
Access to the Web server hosting this page must be granted to all unauthenticated users. Do
this with an appropriate access list definition. (Users see this page after they are logged out.)
Remote login page
Use this value to redirect users to a remote server to log in to the public access interface instead
of using the internal login page.
Although the remote login page feature enables you to host the public access login page on
a remote Web server, authentication of users is still performed by the controller through a
RADIUS server or using the local user list. To accomplish this, the remote Web server must send
user login information back to the controller. There are two ways this can be done: basic remote
Colubris AV-Pair - Site attribute values 469