MSM7xx Controllers Configuration Guide v6.4.0

• Bit-rate and duplex capability
• Current duplex and bit-rating
• Whether these settings were the result of auto-negotiation during link initiation or manual
override.
Configuring LLDP on an AP
AP settings are defined by selecting Controlled APs >> Configuration > LLDP.
LLDP agent
Enable this option to activate LLDP support on the AP. When active, the agent will transmit and
receive LLDP information.
When operating in controlled mode:
• The LLDP agent on an AP will not respond to SNMP requests. Therefore, local and remote MIB
information is not available to external devices via the AP. Instead, this information can be
retrieved from the controller.
• LLDP is not supported on local mesh links.
Supported TLVs
The LLDP agent on an AP supports the following Basic TLVs:
Mandatory TLVs
• Chassis ID (Type 1): The MAC address of the AP.
• Port ID (Type 2): The MAC address of port on which the TLV will be transmitted.
• Time to live (Type 3): Defines the length of time that neighbors will consider LLDP information
sent by this agent to be valid. Calculated by multiplying Transmit interval by the Multiplier.
522 LLDP