MSM7xx Controllers Configuration Guide v6.4.0

As shown in the above image, the Summary list includes a Detected link and count in the Summary
list, and the Network Tree includes an Autonomous APs branch on Controller. These elements only
appear when at least one autonomous APs has been detected. As shown, when Autonomous APs
is selected, the list of Detected Autonomous APs list appears in the right pane.
Select a link in the Device ID column to display the Autonomous APs details like this:
You can also select the link in IP address column to launch the AP management tool. See the
MSM3xx/MSM4xx APs Configuration Guide.
Switching a controlled AP to autonomous mode
To switch a controlled AP to autonomous mode, select the AP in the Controlled APs branch of the
Network Tree, and then in the right pane select Maintenance > System and select Switch to
Autonomous Mode.
534 Working with autonomous APs