MSM7xx Controllers Configuration Guide v6.4.0

3. On the Advanced tab, configure the following:
• From the Vendor class drop-down menu, select Colubris.
• Under Available options, enable the 001 MSC checkbox.
• Under IP address, specify the IP address of the primary controller in your network and
select Add. Continue to build a list by specifying the IP addresses of all controllers in your
network, in descending order of importance.
• Select OK.
4. The controller IP addresses now appear on the DHCP administration page under Scope Options.
When an AP requests an IP address, these addresses are returned in a DHCP Ack message
as option 43.
NOTE: For information on solving problems, see “Troubleshooting” (page 563).
Windows Server 2003 configuration 561