MSM7xx Controllers Configuration Guide v6.4.0

controller can only have one system name. If both the LAN and Internet ports have
active agents, then the name generated by the LAN port is used.
System description
(Type 6): Description of the system, comprised of the following information: operational
mode, hardware type, hardware revision, and firmware version.
System capabilities
(Type 7): Indicates the primary function of the device. Set to:
WLAN access point
for APs
Router
for controllers.
Management IP address
(Type 8): Specify the IP address on which the agent will respond to management
requests.
802.3 TLVs
The IEEE 802.3 organizationally specific TLV set is optional for all LLDP implementations. The
AP supports a single optional TLV from the 802.3 definition.
MAC/PHY configuration/status
This TLV provides the following information:
• Bit-rate and duplex capability
• Current duplex and bit-rating
• Whether these settings were the result of auto-negotiation during link initiation or
manual override.
DNS configuration
The controller provides several options to customize DNS handling. To configure these options,
select Controller >> Network > DNS. The configuration options on this page change depending
on the address option that is active on the Internet port.
When the Internet port (Internet network on the MSM720) is configured to obtain an IP address
via PPPoE or DHCP:
58 Network configuration