MSM7xx Controllers Configuration Guide v6.4.0

On all other controllers
Active routes
This table shows all active routes on the controller. You can add routes by specifying the appropriate
parameters and then selecting Add.
The routing table is dynamic and is updated as needed. This means that during normal operation
the controller adds routes to the table as required. You cannot delete these system routes.
The following information is shown for each active route:
• Interface: The port through which traffic is routed. When you add a route, the controller
automatically determines the interface to be used based on the Gateway address.
• Destination: Traffic addressed to this IP address or subnet is routed.
• Mask: Number of bits in the destination address that are checked for a match.
• Gateway: IP address of the gateway to which the controller forwards routed traffic (known as
the next hop).
An asterisk is used by system routes to indicate a directly connected network.
Routes cannot be manually specified for IPSec. These routes are automatically added by the
system based on the settings for the IPSec security association.
Defining IP routes 61