MSM7xx Controllers Configuration Guide v6.4.0

To create an IP QoS profile, select Add New Profile.
Settings
• Profile name: Specify a unique name to identify the profile.
• Protocol: Specify an IP protocol to use to classify traffic by specifying its Internet Assigned
Numbers Authority (IANA) protocol number. Protocol numbers are pre-defined for a number
of common protocols. If the protocol you require does not appear in the list, select Other and
specify the appropriate number manually. You can find IANA-assigned protocol numbers on
the Internet.
• Start port/ End port: Optionally specify the first and last port numbers in the range of ports
to which this IP QoS profile applies. To specify a single port, specify the same port number
for both Start port and End port. Port numbers are pre-defined for a number of common
protocols. If the protocol you require does not appear in the list, select Other and specify the
appropriate number manually.
NOTE: To accept traffic on all ports for a specified protocol, set Start port to Other and 0.
Also set End port to 65535.
• Priority: Select the priority level that will be assigned to traffic that meets the criteria specified
in this IP QoS profile.
NOTE: It is strongly recommended that you reserve Very high priority for voice applications.
Example
This example shows how to create two IP QoS profiles and associated them with a VSC. The two
profiles are:
• Voice: Provides voice traffic with high priority.
• Web: Provides HTTP traffic with low priority.
Create the profiles
1. Select Controller >>Network > IP QoS, and then Add New Profile. The IP QoS Profile page
opens.
2. Under Profile name, specify Voice.
66 Network configuration