HP 425 Wireless Dual Radio 802.11n Access Point Compliance and Safety Manual

33
USA regulatory compliance
FCC Part 15
US Federal Communications Commission (FCC) EMC Compliance
This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This product complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
If the customer modifies the equipment without the authorization of HP,
which directly or indirectly contribute to the equipment incompliance with
FCC requirements for Class B digital devices, HP is not liable for such
interference problem and the expenses incurred there from shall be
covered by the customers.