MSM7xx Controllers Configuration Guide v6.4.0

The HP VSC profile is defined by default.
• To add a VSC, select VSCs >> Overview > VSC profiles > Add New VSC Profile.
• To edit a VSC, select its name in the VSC list, or in the Network Tree.
In either case, the VSC profile page opens. In this page sample, only the top of the VSC profile
page is shown.
The default VSC
The default VSC is used as a fallback for any traffic that goes through the controller and that cannot
be identified as coming from an MSM AP. It is also used to handle all non-VLAN traffic from wired
devices connected to the controller LAN port (i.e., traffic from 3rd-party APs or wired users on the
network). See “About the default VSC” (page 139).
VSC configuration options
This section provides an overview of all the configuration options available for a VSC. It will give
you a good idea on how the features can be used.
The default VSC is pre-configured as described in the following pages. Below, is an overview of
the entire VSC configuration page.
VSC configuration options 113