MSM7xx Controllers Configuration Guide v6.4.0

DescriptionDiagnostic
The AP unexpectedly requested new authentication certificates from the
controller. Possible causes are as follows:
Suspicious device
◦ A previously synchronized AP was reset to factory defaults.
◦ An unauthorized AP may be using the same MAC address.
This is a possible security breach that should be investigated before
authorizing the AP again.
The AP is up and running, offers wireless services, and had its firmware
and configuration settings successfully updated by the controller.
Synchronized
Although the AP is synchronized it is non-functional (quarantined) due to
a license violation.
Synchronized/License violation
You must change the configuration to omit the affected licensed feature
or acquire and install a valid license.
This AP cannot be added because the maximum number of configured
APs has been reached. To add this AP you must first remove one or more
currently configured APs.
Unconfigurable
No suitable firmware is available for this AP on the controller.Unsupported product
You should upgrade the controller firmware so that the newly-introduced
product can be recognized.
The AP is up and running and offers wireless services. However, its
configuration settings do not match the settings defined on the controller
(at the group or AP level).
Unsynchronized
You should Synchronize the AP.
The AP is not synchronized but can continue operation. However, if
synchronized, it will become non-functional as described above for
Synchronized/License violation.
Unsynchronized/License violation
Before synchronizing, either change the configuration to omit the affected
licensed feature or acquire and install a valid license.
Configuration settings are currently being sent to the AP.Uploading configuration
The controller is uploading new firmware to the AP. Wait until the operation
completes.
Uploading firmware
The controller is waiting for the AP to send its configuration.Validating configuration
The controller is waiting for the AP to send its firmware version number.Validating firmware
The AP has been authorized by the controller. However, the AP has not
yet selected the controller to function as its controller. (If multiple controllers
Waiting for acceptance
replied to the APs discovery request, the AP may choose to connect with
another controller.)
The AP was created with a product type that does not match the detected
product type. This can occur when an AP is manually added to a group
with the wrong product type.
Wrong product
You should verify and fix the product type.
The capabilities of the AP are being identified by the controller.Validating capabilities
• Action: Indicates the recommended administrative action to be taken to resolve a diagnostic
condition.
Discovery of controllers by controlled APs 157