MSM7xx Controllers Configuration Guide v6.4.0

NOTE: The Provision button is only available if the AP is in its factory-default state, meaning
it has not yet been provisioned and that the AP has never discovered a controller (since last
factory default). To force an AP into its factory-default state, press and hold its reset button
until the status lights blink three times.
3. Configure provisioning settings as described in the sections that follow.
Provisioning connectivity
Use the Provisioning > Connectivity page to provision connectivity settings for a controlled AP. The
following page will appear on all APs except for the HP 517 and MSM317.
Enable provisioning here:
Provisioning APs 173