MSM7xx Controllers Configuration Guide v6.4.0

Viewing status information
Basic AP and AeroScout tag status information is available by selecting Controller > Controlled
APs >> Overview > RTLS. For example:
All AeroScout management and monitoring is performed in the AeroScout software itself. Aeroscout
documentation and AeroScout software must be used to operate and monitor the tags.
Values
AP name
Name of the AP on which HP RTLS is enabled.
AP MAC address
MAC address of the AP.
Radio
Radio on the AP to which the AeroScout tag is connected.
Engine
IP address and port to which the controller sends the tag and Mu reports generated by the AP.
Tag states
Shows two values: admin state / operational state
• Admin state: Indicates if the AeroScout engine requested that the AP process frames
generated by AeroScout tags.
• Oper state: Indicates if the radio is actually listening for frames generated by AeroScout
tags.
Mu states
Shows two values: admin state / operational state
• Admin state: Indicates if the AeroScout engine requested that the AP process Mu (mobile
unit) information.
• Oper state: Indicates if the radio is actually listening for Mu (mobile unit) information.
Tag report
Number of tag reports sent to the Aeroscout engine.
Tag adj msg
Number of tag messages that were dropped because they were received on the wrong channel.
Mu report
Number of Mu reports sent to the Aeroscout engine.
Software retrieval/update
Software management of controlled APs is automatically performed by the controller after the AP
is discovered (see “Key controlled-mode events” (page 146)).
If the software version on the AP does not match the version installed on the controller, new software
is installed on the AP by the controller.
For information on how to update the controller software see “Software updates” (page 539).
180 Working with controlled APs