MSM7xx Controllers Configuration Guide v6.4.0

band is probably much busier than the 5 GHz band, so IDS scanning using the 5 GHz radio
has a reduced performance impact.
Channels to scan
• All channels: Scan all channels supported by the current operating mode.
• Regulatory channels only: Scan only channels supported by the current regulatory domain
(country).
• Non-excluded channels only: When enabled, the AP will not scan any channels in the Automatic
channel exclusion list.
Neighbor detection time
Estimated time in seconds to detect a neighbor.
Viewing the RRM radio map
The RRM radio map displays all radios that are detected within the operating area of all controlled
APs. Select Controlled APs >> Radio management > Radios map to see the map. For example:
Filter all entries by
To narrow down the list of radios in the table, select a category and enter text on which to filter
the radio list. Click Apply to activate the filter.
Table
• MAC address: MAC address of the radio.
• AP Name: Name of the AP or identifier, if any.
• Mode:
C: Controlled by this controller.◦
◦ D: Radio is disabled.
Viewing the RRM radio map 187